GPRS network architecture

This GPRS tutorial is split into several pages each of which address different aspects of the GPRS technology:

[1] GPRS technology tutorial
[2] GPRS network architecture
[3] GPRS mobiles and multislot classes
[4] GPRS radio air interface
[5] GPRS error coding
[6] GPRS operation

With GPRS providing a move from circuit switched technology to packet switched technology, it was necessary to upgrade the network architecture to accommodate this. To accommodate this the GPRS network architecture added new elements including the GGSN and SGSN to the existing GSM network to be able to accommodate this.

However it was still necessary for the GPRS network elements and those from the existing GSM elements to work along side one another. Accordingly the introduction of GPRS technology saw the addition of some new entities within the over network architecture.

GPRS network architecture upgrades

With GPRS providing additional connectivity in terms of packet data, there are naturally a number of upgrades needed to the network architecture required. A number of new elements are needed for the network, but these can operate alongside the existing elements meaning that the GPRS capability is an upgrade to the network and not a completely new network structure.

The main new network architecture entities that are needed are:

• SGSN: GPRS Support Node - this forms a gateway to the services within the network.



• GGSN: Gateway GPRS Support Node which forms the gateway to the outside world.



• PCU: Packet Control Unit which differentiates whether data is to be routed to the packet switched or circuit switched networks.

A simplified view of the GPRS network architecture can be seen in the diagram below. From this it can be seen that it is very similar to the more basic GSM network architecture, but with additional elements.

GPRS network architecture

SGSN

The SGSN or Serving GPRS Support Node element of the GPRS network provides a number of takes focussed on the IP elements of the overall system. It provides a variety of services to the mobiles:

• Packet routing and transfer



• Mobility management



• Attach/detach



• Logical link management



• Authentication



• Charging data

There is a location register within the SGSN and this stores location information (e.g., current cell, current VLR). It also stores the user profiles (e.g., IMSI, packet addresses used) for all the GPRS users registered with the particular SGSN.

GGSN

The GGSN, Gateway GPRS Support Node is one of the most important entities within the GPRS network architecture.

The GGSN organises the interworking between the GPRS network and external packet switched networks to which the mobiles may be connected. These may include both Internet and X.25 networks.

The GGSN can be considered to be a combination of a gateway, router and firewall as it hides the internal network to the outside. In operation, when the GGSN receives data addressed to a specific user, it checks if the user is active, then forwarding the data. In the opposite direction, packet data from the mobile is routed to the right destination network by the GGSN.

PCU

The PCU or Packet Control Unit is a hardware router that is added to the BSC. It differentiates data destined for the standard GSM network (circuit switched data) and data destined for the GPRS network (Packet Switched Data). The PCU itself may be a separate physical entity, or more often these days it is incorporated into the base station controller, BSC, thereby saving additional hardware costs.

GPRS network upgrading

One of the key elements for any network operator is the cost of capital expenditure (capex) to buy and establish a network. Capex costs are normally very high for a new network, and operators endeavour to avoid this and use any existing networks they may have to make the optimum use of any capital. In addition to the capex, there are the operational costs, (opex). These costs are for general maintenance and other operational costs that may be incurred. Increasing efficiency and reliability will reduce the opex costs.

Any upgrade such as that from GSM to GPRS will require new investment and operators are keen to keep this to the minimum. The upgrades for the GPRS network are not as large as starting from scratch and rolling out a new network.

The GPRS network adds to the existing GSM network. The main new entities required within the network are the SGSN and GGSN, and these are required as the starting point.

The base station subsystems require some updates. The main one is the addition of the PCU described above. Some modifications may be required to the BTS, but often only a software upgrade is required, and this may often be achieved remotely. In this way costs are kept to a minimum.

Summary

The GPRS network architecture can be viewed as an evolution of the GSM network carrying both circuit switched and packet data. The GPRS network architecture was also used as the basis for the 3G UMTS network. In this way network operators could evolve their networks through GPRS and possibly EDGE to the full 3G networks without having to replace and install more new equipment than was absolutely necessary.